Home T&M Products Multifunction Installation Testers

Sonel EVSE-01 Adapter for Testing Electric Vehicle Charging Stations

Sonel Adpator for Electric Vehicle Charging Stations for use with MPI models

For use with MPI-540PV, MPI-540 and MPI-506

Adapter allows to perform comprehensive measurements of electric vehicle charging stations - quickly and in accordance with applicable regulations. Simulating the charging cable (proximity pilot line - PP) and vehicle connection status (control pilot line - CP), it will bring the station into different operating states. This will enable measurements in the field of electric shock protection:

Quick and full diagnostics of charging stations

ZS fault loop impedance
checking the parameters of RCD residual current devices
RISO insulation resistance
Technical specifications:

Measurement category according to EN 61010-1: CAT II 300 V
Ingress protection according to EN 60529: IP40
Input voltage: 400 V (3-phase)
Pollution degree: 2
Frequency: 50 Hz
Simulation of charging cable PP: open circuit, 13 A, 20 A, 32 A, 63 A
Vehicle connection simulation CP:
State A: vehicle not connected
State B: vehicle connected, not charging
State C: vehicle connected, charging without ventilation
State D: vehicle connected, charging with ventilation
State E: error - CP short to PE
Socket types:
Measuring sockets: L1, L2, L3, N, PE
CP signal socket - PWM communication

Multifunction Installation Testers


In order to assist us in reducing spam, please type the characters you see:

You may also like